wastewater treatment - Sludge treatment and disposal

07 Dec.,2022


containerized water treatment plant for sewage treatment

Treatment of sewage sludge may include a combination of thickening, digestion, and dewatering processes.

Thickening is usually the first step in sludge treatment because it is impractical to handle thin sludge, a slurry of solids suspended in water . Thickening is usually accomplished in a tank called a gravity thickener. A thickener can reduce the total volume of sludge to less than half the original volume. An alternative to gravity thickening is dissolved-air flotation. In this method, air bubbles carry the solids to the surface, where a layer of thickened sludge forms.


Sludge digestion is a biological process in which organic solids are decomposed into stable substances. Digestion reduces the total mass of solids, destroys pathogens, and makes it easier to dewater or dry the sludge. Digested sludge is inoffensive, having the appearance and characteristics of a rich potting soil.

Most large sewage treatment plants use a two-stage digestion system in which organics are metabolized by bacteria anaerobically (in the absence of oxygen). In the first stage, the sludge, thickened to a dry solids (DS) content of about 5 percent, is heated and mixed in a closed tank for several days. Acid-forming bacteria hydrolyze large molecules such as proteins and lipids, breaking them into smaller water-soluble molecules, and then ferment those smaller molecules into various fatty acids. The sludge then flows into a second tank, where the dissolved matter is converted by other bacteria into biogas, a mixture of carbon dioxide and methane. Methane is combustible and is used as a fuel to heat the first digestion tank as well as to generate electricity for the plant.

Anaerobic digestion is very sensitive to temperature, acidity, and other factors. It requires careful monitoring and control. In some cases, the sludge is inoculated with extra hydrolytic enzymes at the beginning of the first digestion stage in order to supplement the action of the bacteria. It has been found that this enzymatic treatment can destroy more unwanted pathogens in the sludge and also can result in the generation of more biogas in the second stage of digestion.

Another enhancement of the traditional two-stage anaerobic digestion process is thermal hydrolysis, or the breaking down of the large molecules by heat. This is done in a separate step before digestion. In a typical case, the process begins with a sludge that has been dewatered to a DS content of some 15 percent. The sludge is mixed with steam in a pulper, and this hot homogenized mixture is fed to a reactor, where it is held under pressure at approximately 165 °C (about 330 °F) for about 30 minutes. At that point, with the hydrolytic reactions complete, some of the steam is bled off (to be fed to the pulper), and the sludge, still under some pressure, is released suddenly into a “flash tank,” where the sudded drop in pressure bursts the cell walls of much of the solid matter. The hydrolyzed sludge is cooled, diluted slightly with water, and then sent directly to the second stage of anaerobic digestion.

Sludge digestion may also take place aerobically—that is, in the presence of oxygen. The sludge is vigorously aerated in an open tank for about 20 days. Methane gas is not formed in this process. Although aerobic systems are easier to operate than anaerobic systems, they usually cost more to operate because of the power needed for aeration. Aerobic digestion is often combined with small extended aeration or contact stabilization systems.

Aerobic and conventional anaerobic digestion convert about half of the organic sludge solids to liquids and gases. Thermal hydrolysis followed by anaerobic digestion can convert some 60 to 70 percent of the solid matter to liquids and gases. Not only is the volume of solids produced smaller than in conventional digestion, but the greater production of biogas can make some wastewater treatment plants self-sufficient in energy.